Chain-stitched rope collar bondage technique

articles and tutorials bondage techniques Rope cuffs and bondage restraints

Have you ever been someplace, and everyone else has their submissives on leashes, and your submissive doesn't have her collar with her? Or maybe you a playing with a new submissive, and want them to feel the joy of being leashed, but you don't have a spare collar with you. Or maybe you'd just like to use rope for everything you do.

Here is a way to make a quick collar and leash, using just a single length of rope. The collar will not tighten when you pull on the leash, which makes it safer, and it is thick enough that it will not cut into your partner's neck. Since it takes a few minutes to remove it, you should make sure you have EMT shears with you, in case it turns out that you made it too tight, and you need to quickly remove it.

Take a 25-foot length of rope, and double it. We will be working with the bight (doubled) end.

Twist the loop. It doesn't matter which way you twist it.

If you look where the two rope ends cross, one of them goes underneath the other one. Take that end and fold it to make another bight. This bight is going to go through the loop we made when we twisted the first bight.

Push the bight through...

Then pull on the other end to tighten things up.

Now take the end that you just pulled on, and double it to form a bight. This is going to go through the loop we just made.

Like this...

Then we pull on the other end...

And tighten things up. Keep repeating this procedure. If you ever get confused about where you are, here is how to get your bearings. There are two ends. One connects to the current loop, and if you push or pull it, the loop will get larger or smaller. The other end, the one that is connected to a knot, is the one we double to make a new bight.

When you have chain-stitched enough for the collar to go around your partner's neck comfortably, find the orginal loop at the beginning of the collar, and pull it out a little bit.

If you look at the two ends you have, one of them is connected to the loop, and the other one is the one that will make the next bight. Before it does so, we are going to run it through the original loop at the beginning of the collar.

So push the end through the loop...

And pull the rope through. At this time, you should put the collar around your partner's neck.

And keep pulling on the end until the ends of the collar are together.

Now, before you let go of that rope, make a new bight with it and push it through the loop.

Like this.

And pull on the other rope to tighten things up. In other words, we are back to the same routine we were doing before.

ventually, your rope end will get too short to make any more bights. Take the short end and push it through the the last loop you made.

Pull it tight, and you're done.

Here is what the completed collar looks like.

modelstied presents more bondage:

Comments: 0 Make a comment