The Crupper - genital bondage illustrated tutorial

So simple yet so effective! And it has the look of a piece of clothing; some prefer the submissive to be wearing a little something because they find it sexier than total nudity. If that is you, the crupper will suit your needs quite nicely. If that is not you, then there are other uses for the crupper that you may find more interesting The most interesting of these being that a nice, tightly tied crupper can be used to hold objects you have inserted into him in him, for just about as long as you like. And if you read the instructions carefully and look at the illustrations, you will see that the crupper is almost the same as the basic restraint, only done around the waist and genitals rather than the wrists and ankles.

Step One

Fold your rope in half. Put the folded rope around his waist and pull the two loose ends through the loop. Pull the two ends back over the top of the loop and around his waist, making four strands of rope around his waist. (See illustrations 10 and 11.)

Step Two

When you return the rope to the front of the securing ropes at the waist, loop the two ends over the top of the back loop. Pull to tighten. Now you have two loose ends hanging down. (See illustration 12.)

Step Three

Pull the two loose ends down between his legs and up the crack of his ass. Loop them under then over the quadrupled rope at the small of his back, then pull them in the opposite direction: down his crack and up his belly. As you pull the rope back and forth between his legs, you can arrange his cock and balls within the ropes so that when you pull the ropes tight, they will have their maximum effect on his basket. You’ll see. (Refer to illustrations 13 and 14.)

Step Four

So now the two loose ends are ready to be tied off. As you bring them up his belly separate the tw'o strands. Pull up one under either far side of the rope cluster, making sure to go under all of the other ropes. Wrap each end around all of the other ropes twice, looping toward his belly button, and leaving enough room for your index finger. After you have gone around twice, pull the rope end through the double loop you just created, and then back through the last loop. Pull to tighten. Tuck any excess rope tidily into the rope array. (See illustrations 15 and 16.)

Illustrations 17, 18, 19, and 20 are closeups of the above tie-off.

If you wish to use the crupper to hold a plug in his ass, insert the plug first.